HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 411)

Figure 118 System configuration for backing up and restoring storage groups to and from tape
With Application Agent, database servers can be clustered. With database servers configured in a
failover cluster, if the active server fails, a standby server is available to take over operations from
the active server.
The examples in this section assume the following conditions:
• The primary volume is NTFS-formatted.
• The primary volume and the secondary volume are pair defined in the database server and the
backup server.
• The tape backup management software is installed on the backup server.
• The parameters of the tape backup management software have been registered by using the
drmtapeinit command.
• The FTP service on the backup server is started, and the system is set up so a user who has logged
onto the OS of the database server can log onto the FTP server and transfer files to the FTP server.
The FTP user ID is
admin , and the FTP user password is password .
• The Exchange Server used in the system is an Exchange Server 2003 Enterprise Edition.
• The storage group ( STORAGE_1) exists on database server ( DBServer ), and services are running
on database server.
• Temporary directory for Extended Commands is created by the database server and backup
server.
• The secondary volume is not always mounted. It is mounted on the E drive (drive character E: )
only while it is operating.
Application Agent CLI User Guide 411