HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 219)

4. Carry out the procedure described in this manual for restoration.
Creating the Exchange environment configuration file
The Exchange environment configuration file is used to specify the information required for Exchange
Server linkage. If you use the automatic seed function in a CCR configuration, you must create the
Exchange environment configuration file.
Create the Exchange environment configuration file under a desired name in the following location:
Application-Agent-installation-target \DRM\conf\exchange\
Exchange-environment-configuration-file-name
.conf
When you install Application Agent, a sample Exchange environment configuration file is created in
the following location:
Application-Agent-installation-target \DRM\conf\exchange\sample\exchange.conf
The following table lists and describes the parameters in the Exchange environment configuration file.
Table 76 Parameters in the Exchange environment configuration file
Maximum
Character
String (bytes)
Default Description Parameter
3 OFF
This parameter is effective only in a CCR
configuration with Exchange Server 2007.
Specify whether the automatic seed function
is to be enabled or disabled.
To enable the automatic seed function,
specify
ON ; to disable the function, specify
OFF .
EXG_CCR_SEED
255 None
This parameter is effective only in a CCR
configuration with Exchange Server 2007.
This parameter is required if you have
specified
ON in the EXG_CCR_SEED
parameter.
Specify the host name or IP address of the
standby server. You can specify the IP
address in IPv4 or IPv6 format.
EXG_CCR_PASSIVE_NODE
3 OFF
This parameter is effective only in an SCR
configuration with Exchange Server 2007.
Specify whether the seed function is to be
enabled in the SCR configuration.
To enable the seed function, specify
ON.
To disable the function, specify OFF .
If the -ef option is omitted or the
EXG_SCR_SEED parameter is missing, OFF
is assumed.
EXG_SCR_SEED
Application Agent CLI User Guide 219