HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 135)

2. Create the dictionary map files and backup catalog on each shared disk.
At the two servers comprising the cluster configuration, place the virtual server into the Active
status, and then execute the drmdbsetup utility as shown below:
Before you execute the drmdbsetup utility, you must set the virtual server name in the
DRM_HOSTNAME environment variable. Note that if you omit the virtual server name, the system
creates dictionary map files in the default dictionary map files storage directory instead of creating
it on the shared disk, which invalidates the cluster settings by Application Agent.
If the backup target is an Exchange database, specify the name of the Exchange virtual server
as the virtual server name.
To execute the drmdbsetup utility, specify the following commands:
PROMPT> set DRM_HOSTNAME=VHOST1
PROMPT> Application-Agent-installation-folder \DRM\bin\util\drmdbsetup -i
PROMPT> set DRM_HOSTNAME=VHOST2
PROMPT> Application-Agent-installation-folder \DRM\bin\util\drmdbsetup -i
When the dictionary map files and backup catalog are created, the following message appears:
All data files were created.
3. When Veritas Cluster Server is used, execute the drmclusinit command to register cluster
resource information.
For details, see “ Creating a cluster information configuration definition file when using Veritas
cluster server ” on page 139.
Creation in a cascade configuration for Exchange database backup
To back up an Exchange database in a cascade configuration, you must create dictionary map files
in an arbitrary directory at both the local and remote sites.
Perform the following procedure to create the dictionary map files.
To create dictionary map files in an arbitrary directory:
Application Agent CLI User Guide 135