HP Serveur lame HP ProLiant BL465c Gen8 User Manual
Page 482
10.
From the backup server, back up the data on the secondary volume to a tape device.
An unused backup ID (
0000000002
) is assigned.
PROMPT> drmmediabackup 0000000001
KAVX0001-I The drmmediabackup command will now start.
KAVX0402-I Backup processing will now start.
To see more details on backup progress, use the monitoring
method of
the backup management product.
Source = W:
KAVX0402-I Backup processing will now start.
To see more details on backup progress, use the monitoring
method of
the backup management product.
Source = X:
KAVX0403-I Backup processing has finished.
Source = W:
KAVX0403-I Backup processing has finished.
Source = X:
KAVX0040-I The backup ID has been assigned as follows:
Backup ID = 0000000002
KAVX0002-I The drmmediabackup command will now end.
PROMPT>
11.
Confirm that the backup to the tape device was successful.
From the backup server, check to see if the backup to the tape device has successfully completed:
PROMPT> drmtapecat -backup_id 0000000002
BACKUP-ID BACKUP-OBJECT SNAPSHOT TIME EXPIRATION TIME BACKUP-MEDIA
0000000002 MSEXCHANGE 2002/06/01 11:00:00 2002/06/02 11:00:00 MEDIA1
PROMPT>
12.
Unmount the secondary volume where the backup data is stored.
Specify the backup ID that was assigned when the backup was imported (
0000000001
) to
unmount the secondary volume.
PROMPT> drmumount 0000000001
KAVX0001-I The drmumount command will now start.
KAVX0406-I Unmounting will now start.
Mount point = W:
KAVX0407-I Unmounting has finished.
Mount point = W:
KAVX0406-I Unmounting will now start.
Mount point = X:
KAVX0407-I Unmounting has finished.
Mount point = X:
KAVX0002-I The drmumount command will now end.
PROMPT>
Roll-forward recovery on backed up data acquired in an SCR configuration
This section provides an example of how to perform a roll-forward recovery on a storage group, using
backed up data that was acquired in an SCR configuration. This example uses the backup data
acquired in “
Backing up in an SCR configuration
1.
From the backup server, start the Protection Manager service.
Operation for Exchange databases
482