HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 492)

11. While the SCR seed function is still enabled, perform a point-in-time restoration on the backup
data from the secondary volume to the primary volume.
PROMPT> drmexgrestore 0000000002 -resync -recovery -ef exchange.conf
KAVX0001-I The drmexgrestore command will now start.
KAVX1526-I The Exchange environment configuration file has been read.
Exchange environment configuration file = exchange.conf
KAVX0256-I A connection to the Protection Manager service will now be established.
Host name = Target
KAVX0256-I A connection to the Protection Manager service will now be established.
Host name = Backupserver
KAVX1741-I The replication function of Exchange Server has stopped.
Target = Target
Storage group name = STR1
KAVX1805-I The information store will now be dismounted.
Storage group name = STR1
KAVX1700-I Restore processing will now start.
KAVX5111-I Performing unmounting.
Mount point name = D:
KAVX5111-I Performing unmounting.
Mount point name = E:
KAVX5108-I Resynchronizing a copy group.
Copy group name = EXG001,B001
KAVX5108-I Resynchronizing a copy group.
Copy group name = EXG002,B001
KAVX5109-I Dividing a copy group in pair.
Copy group name = EXG001,B001
KAVX5109-I Dividing a copy group in pair.
Copy group name = EXG002,B001
KAVX5110-I Performing mounting.
Mount point name = E:
KAVX5110-I Performing mounting.
Mount point name = D:
KAVX1701-I Restore processing has finished.
KAVX1806-I The information store will now be mounted.
Storage group name = STR1
KAVX1745-I The seed processing will now start.
Target = Target
Storage group name = STR1
KAVX1746-I The seed processing has finished.
Target = Target
Storage group name = STR1
KAVX1743-I The replication function of Exchange Server has resumed.
Target = Target
Storage group name = STR1
KAVX0002-I The drmexgrestore command will now end.
Backing up and restoring in DAG configurations
If a system is composed of multiple database servers that make up a DAG configuration and multiple
backup servers, you can back up and restore the active mailbox database copy and the passive
mailbox database copy separately. The procedure outlined in this section for backing up and restoring
the active mailbox database copy can also be used for a system configuration in which only the active
mailbox database copy is backed up and restored. Similarly, the procedure for backing up and
restoring the passive mailbox database copy here can also be used for a system configuration in
which only the passive mailbox database copy is backed up and restored.
Below is an example of when Exchange Server 2010 is used.
System Configuration
The following figure shows an example of a system configuration.
Operation for Exchange databases 492