HP Serveur lame HP ProLiant BL465c Gen8 - Manual (Page 97)

3 Preparation for using Application Agent
This chapter explains the flow of environment setup required for using Application Agent, and gives
details on each step in the environment setup. The descriptions in this chapter apply to the Application
Agent CLI.
Setting up an environment for Application Agent
Table 4-1 shows the procedures for setting up an environment for Application Agent and the tasks
required for each server. To set up the environment, refer to the tasks marked "Needed" for each type
of server in the table.
Sometimes Application Agent commands need to be executed during environment setup. Administrator
permissions are required to execute Application Agent commands. For details on user permissions
for executing commands, see “
Permissions required for users executing commands ” on page 233.
NOTE:
If you omit specifying the parameters for setting up an environment or specify an invalid value (a
value that cannot be set), the default values will be used.
Table 9 Application Agent environment setup tasks needed for each kind of server
Sections and
documents for
reference
File name
Backup
server
File serv-
er
or
database
server
Environment setup task
Documentation
for the storage
system
--
Not
needed
#2
Not
needed
#2
Set up the
volume rep-
lication func-
tionality of
the storage
system.
Set up the en-
vironment for
prerequisite
products.
#1
Setting up RAID
Man-
ager
, page 100
RAID Manager configuration
definition file (
horcm n .conf )
Needed Needed
Set up RAID
Manager
Documentation
for the tape
backup man-
agement soft-
ware
-- Needed
Not
needed
Set up the
tape backup
management
software
Application Agent CLI User Guide 97