Allied Telesis AT-S63 - Manual (Page 122)

Chapter 7: Port Parameter Commands
122 Section I: Basic Operations
The following command sets the speed on ports 2 to 6 to 100 Mbps, the
duplex mode to full duplex, the wiring configuration to MDI-X, and flow
control to enabled:
set switch port=2-6 speed=100mfull mdimode=mdix
flowcontrol=enabled
The following command resets port 5:
set switch port=5 softreset
Equivalent Commands
disable switch port= port
For information, see “DISABLE SWITCH PORT” on page 112.
disable switch port= port flow=pause
For information, see “DISABLE SWITCH PORT FLOW” on page 113.
enable switch port= port
For information, see “ENABLE SWITCH PORT” on page 115.
enable switch port= port flow=pause
For information, see “ENABLE SWITCH PORT FLOW” on page 116.
reset switch port= port
For information, see “RESET SWITCH PORT” on page 118.