Allied Telesis AT-S63 - Manual (Page 465)

AT-S63 Management Software Command Line Interface User’s Guide
Section V: Spanning Tree Protocols 465
ADD MSTP
Syntax
add mstp mstiid= mstiid mstivlanassoc= vids
Parameters
mstiid Specifies the ID of the multiple spanning tree instance
(MSTI) to which you want to associate VLANs. You can
specify only one MSTI ID at a time. The range is 1 to
15.
mstivlanassoc Specifies the VID of the VLAN you want to associate
with the MSTI ID. You can specify more than one VID at
a time (for example, 2,5,44).
Description
This command associates VLANs to a MSTI.
The MSTIID parameter specifies the MSTI ID. The MSTI must already
exist on the switch. To create a spanning tree instance, see “CREATE
MSTP” on page 466.
The MSTIVLANASSOC parameter specifies the VIDs of the VLANs you
want to associate with the MSTI. The VLANs must already exist on the
switch. Any VLANs already associated with the MSTI are retained. If you
want to add VLANs to a MSTI while removing those already associated to
it, see “SET MSTP MSTIVLANASSOC” on page 478.
Examples
The following command associates the VLAN with the VID 4 to MSTI ID 8:
add mstp mstiid=8 mstivlanassoc=4
The following command associates the VLANs with the VIDs 24 and 44 to
MSTI ID 11:
add mstp mstiid=11 mstivlanassoc=24,44