Allied Telesis AT-S63 User Manual
Page 417
AT-S63 Management Software Command Line Interface User’s Guide
Section IV: SNMPv3
417
Description
This command modifies an SNMPv3 Target Address Table entry.
Examples
The following command modifies the Target Address Table entry with a
value of “snmphost.” The params parameter is set to “targetparameter7”
and the IP address is 198.1.1.1. The taglist is set to “systemtesttraptag”
and “systemtestinformtag.”
set snmpv3 targetaddr=snmphost params=targetparameter7
ipaddress=198.1.1.1 taglist=systemtesttraptag
systemtestinformtag
The following command modifies the Target Address Table entry with a
value of “host.” The params parameter is set to “targetparameter22” and
the IP address is 198.1.1.198. The taglist is set to “engineeringtraptag”
and “engineeringinformtag.”
set snmpv3 targetaddr=host params=targetparameter22
ipaddress=198.1.1.198 taglist=engineeringtraptag
engineeringinformtag