Allied Telesis AT-S63 - Manual (Page 471)

AT-S63 Management Software Command Line Interface User’s Guide
Section V: Spanning Tree Protocols 471
PURGE MSTP
Syntax
purge mstp
Parameters
None.
This command returns all MSTP bridge and port parameters settings to
their default values. This command also deletes all multiple spanning tree
instances and VLAN associations.
In order for you to use this command, MSTP must be the active spanning
tree protocol on the switch and the protocol must be disabled. To select
MSTP as the active spanning tree protocol on the switch, see “ACTIVATE
MSTP” on page 464. To disable MSTP, refer to “DISABLE MSTP” on
page 469.
Example
The following command resets the MSTP bridge and port parameter
settings:
purge mstp
Equivalent Command
set mstp default
For information, see “SET MSTP” on page 472.