Allied Telesis AT-S63 - Manual (Page 67)

AT-S63 Management Software Command Line Interface User’s Guide
Section I: Basic Operations 67
SHOW SYSTEM
Syntax
show system
Parameters
None.
Description
This command displays the following information:
MAC Address
The MAC address of the switch.
Model Name
The model name of the switch.
Serial Number
The serial number of the switch.
IP Address
The IP address of the local interface.
Subnet Mask
The subnet mask of the local interface.
Note
To manage routing interfaces and designate a local interface, refer
to Chapter 32, “Internet Protocol Version 4 Packet Routing” on page
545
Default Gateway
For AT-9400 Series switches that support IPv4 routing, such as the
AT-9448Ts and AT-9448Ts/XP switches, this field displays the IP address
of the next hop of the switch’s default route. The switch uses the default
route when it receives a network packet for routing, but cannot find a route
for it in the routing table. This field will contain 0.0.0.0 if no default route is
defined on the switch.
For AT-9400 Series switches that do not support IPv4 packet routing, such
as the AT-9424T/GB and AT-9424T/SP switches, this field displays the
default gateway address. This is the IP address of a router interface on
your network. The switch’s management software uses this address as the
next hop to reaching a remote network device when the switch’s local
interface and the remote device are on different subnets. The default value