Delete ip rip – Allied Telesis AT-S63 User Manual
Page 578
Chapter 32: Internet Protocol Version 4 Packet Routing
578
Section VII: Internet Protocol Routing
DELETE IP RIP
Syntax
delete ip rip interface=
interface
Parameters
interface
Specifies the name of the interface where RIP is to be
removed. The name consists of “VLAN” followed by a
VID and an interface number, separated by a dash
(e.g., vlan4-0). For background information, refer to
“Interface Names” on page 550.
Description
This command removes RIP from an interface. This stops the interface
from routing packets with RIP. However, an interface, even without RIP,
continues to route packets to other interfaces on the same switch. It also
routes packets to remote networks and subnets using the static routes.
To view the names of the interfaces using RIP, refer to “SHOW IP RIP
COUNTER” on page 596.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command removes RIP from the VLAN8-0 interface:
delete ip rip interface=vlan8-0