Allied Telesis AT-S63 - Manual (Page 598)

Chapter 32: Internet Protocol Version 4 Packet Routing
598 Section VII: Internet Protocol Routing
SHOW IP RIP INTERFACE
Syntax
show ip rip interface[= interface ]
Parameters
interface Specifies the interface name. The name consists of
“VLAN” followed by a VID and an interface number,
separated by a dash (e.g., vlan4-0). If no interface
value is specified, the switch displays all the
interfaces where the routing protocol has been
added. For background information, refer to “Interface
Names” on page 550.
Description
This command lists the routing interfaces where RIP has been assigned
and the RIP settings. An example of the information displayed by this
command is shown in Figure 51.
Figure 51. SHOW IP RIP Command
The columns in the display are described here:
ˆ Interface - An interface name consisting of a VLAN’s identification
(VID) number and interface number. For background information, refer
to “Interface Names” on page 550.
ˆ Send - The version of RIP packets sent by the interface. Possible
settings are:
– RIP1: version 1 packets
– RIP2: version 2 packets
ˆ Receive - The version of RIP packets the interface will accept.
Possible settings are:
– RIP1: version 1 packets
– RIP2: version 2 packets
-----------------------------------------------------------
Interface
Send Receive Auth Password
-----------------------------------------------------------
vlan2-0
RIP2 BOTH PASS ********
vlan5-0 RIP1 BOTH NONE NOT SET
vlan8-0 RIP2 BOTH PASS ********
vlan8-1 RIP2 BOTH PASS ********