Allied Telesis AT-S63 - Manual (Page 478)

Chapter 27: Multiple Spanning Tree Protocol Commands
478 Section V: Spanning Tree Protocols
SET MSTP MSTIVLANASSOC
Syntax
set mstp mstivlanassoc mstiid= mstiid vlanlist= vids
Parameters
mstiid Specifies the ID of the spanning tree instance where
you want to associate VLANs. You can specify only one
MSTI ID at a time. The range is 1 to 15.
vlanlist Specifies the VID of the VLAN you want to associate
with the MSTI ID. You can specify more than one VID at
a time (for example, 2,5,44). If VLANs have already
been associated with the MSTI, they are overwritten.
Description
This command associates VLANs to spanning tree instances.
The MSTIID parameter specifies the ID of the spanning tree instance. The
spanning tree instance must already exist on the switch. To create a
spanning tree instance, see “CREATE MSTP” on page 466.
The VLANLIST parameter specifies the VID of the VLANs you want to
associate with the MSTI. The VLANs must already exist on the switch. If
VLANs are already associated with the MSTI, they are removed and
returned to CIST. If you want to add VLANs to an MSTI and retain those
VLANs already associated with it, see “ADD MSTP” on page 465.
Examples
The following command associates the VLAN with the VID 4 to MSTI ID 8:
set mstp mstivlanassoc mstiid=8 vlanlist=4
The following command associates VIDs 24 and 44 to MSTI ID 11:
set mstp mstivlanassoc mstiid=11 vlanlist=24,44