Enable mstp – Allied Telesis AT-S63 User Manual
Page 470
Advertising
Chapter 27: Multiple Spanning Tree Protocol Commands
470
Section V: Spanning Tree Protocols
ENABLE MSTP
Syntax
enable mstp
Parameters
None.
Description
This command enables Multiple Spanning Tree Protocol on the switch. To
view the current status of MSTP, refer to “SHOW MSTP” on page 483.
You must select MSTP as the active spanning tree on the switch before
you can enable it with this command. To activate MSTP, see “ACTIVATE
MSTP” on page 464.
Example
The following command enables MSTP:
enable mstp
Advertising