Allied Telesis AT-S63 - Manual (Page 590)

Chapter 32: Internet Protocol Version 4 Packet Routing
590 Section VII: Internet Protocol Routing
SHOW IP ARP
Syntax
show ip arp
Parameters
None.
Description
This command displays the entries in the ARP cache. The ARP cache
contains mappings of IP addresses to physical addresses for hosts where
the switch has recently routed packets. For background information, refer
to “Address Resolution Protocol (ARP) Table” on page 555.
Figure 47 is an example of the information displayed by this command.
Figure 47. SHOW IP ARP Command
The columns in the display are:
ˆ Interface - Interface from where the network device is accessed.
ˆ IP Address - IP address of the node.
ˆ MAC Address - MAC address of the node.
ˆ Port - Port on the switch from where the node is accessed.
ˆ Type - Type of entry. This is one of the following:
– Static: Static entry added with “ADD IP ARP” on page 568.
– Dynamic: Entry learned from ARP request/reply exchanges.
– Invalid: Possible nonexistent entry.
– Other: Entry automatically generated by the system.
To set the ARP timeout value, refer to “SET IP ARP TIMEOUT” on
page 582.
-----------------------------------------------------------------
Interface
IP Address MAC Address Port Type
-----------------------------------------------------------------
vlan2-0
149.122.34.4 00:06:5B:B2:44:21 2 Dynamic
vlan2-0 149.122.34.12 00:A0:D2:18:EE:A1 3 Dynamic
vlan2-0 149.122.34.21 00:A0:C3:57:32:14 4 Dynamic
vlan8-1 149.122.35.1 00:A0:64:B1:76:A5 7 Dynamic