Allied Telesis AT-S63 - Manual (Page 92)

Chapter 6: SNMPv2 and SNMPv2c Commands
92 Section I: Basic Features
CREATE SNMP COMMUNITY
Sy nt a x
create snmp community=" community " [access=read|write]
[open=yes|no|on|off|true|false] [traphost= ipaddress ]
[manager= ipaddress ]
Pa r a me t e r s
community Specifies a new community string. The maximum length
of a community string is 15 alphanumeric characters.
Spaces are allowed. The name must be enclosed in
double quotes if it includes a space or other special
character such as an exclamation point. Otherwise, the
quotes are optional. The string is case sensitive.
access Specifies the access level of the new community string.
Options are “read” for read only access and “write” for
both read and write access. The default is “read.”
open Specifies the open or closed status of the community
string. The options are:
yes, on, true The community string is open, meaning
any management station can use the
string to access the switch. These values
are equivalent.
no, off, false The community string is closed, meaning
only those management stations whose
IP addresses are assigned to the string
can use it to access the switch. You can
assign a management IP address to the
string using the MANAGER option in this
command. The default setting for a
community string is closed. These
values are equivalent.
traphost Specifies the IP address of a trap receiver to receive
system traps.
manager Specifies the IP address of a management station that
can use the community string to access the switch. This
option applies if you specify the status of the community
string as closed. A community string can have up to
eight IP addresses of management stations, but only
one can be assigned with this option.