Set ip arp, Age 581 – Allied Telesis AT-S63 User Manual
Page 581
AT-S63 Management Software Command Line Interface User’s Guide
Section VII: Internet Protocol Routing
581
SET IP ARP
Syntax
set ip arp=
ipaddress
[interface=
interface
] [port=
port
]
[ethernet=
macaddress
]
Parameters
arp
Specifies the IP address of the static route entry to be
modified.
interface
Specifies a new interface where the host is located.
An interface name consists of “VLAN” followed by a
VID and an interface number, separated by a dash
(e.g., vlan4-0). The interface must already exist on the
switch. For background information, refer to “Interface
Names” on page 550.
port
Specifies a new physical port on the switch where the
host is located.
ethernet
Specifies a new MAC address of the host. The MAC
address can be entered in either of the following
formats:
xxxxxxxxxxxx or xx:xx:xx:xx:xx:xx
Description
This command modifies an existing static ARP entry in the ARP cache.
You can change all of the settings of an entry, except the IP address. To
change the IP address, you must delete the entry and add it again. To
view the ARP entries, refer to “SHOW IP ARP” on page 590.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command modifies the port number for the static ARP entry with the
IP address 149.42.67.8:
set ip arp=149.42.67.8 port=24
This command changes the MAC address for the static ARP entry with the
IP address 149.124.85.14:
set ip arp=149.124.85.14 ethernet=00:06:7a:22:11:24