Allied Telesis AT-S63 - Manual (Page 435)

435
Chapter 25
Spanning Tree Protocol Commands
This chapter contains the following commands:
ˆ “ACTIVATE STP” on page 436
ˆ “DISABLE STP” on page 437
ˆ “ENABLE STP” on page 438
ˆ “PURGE STP” on page 439
ˆ “SET STP” on page 440
ˆ “SET STP PORT” on page 443
ˆ “SET SWITCH MULTICASTMODE” on page 445
ˆ “SHOW STP” on page 447
Note
Remember to save your changes with the SAVE CONFIGURATION
command.
Note
For background information on this feature, refer to Chapter 22,
“Spanning Tree and Rapid Spanning Tree Protocols” in the AT-S63
Management Software Menus Interface User’s Guide.