Allied Telesis AT-S63 - Manual (Page 148)

Chapter 9: MAC Address Table Commands
148 Section I: Basic Operations
RESET SWITCH FDB
Syntax
reset switch fdb [port= port ]
Parameter
port Specifies the port whose dynamic MAC addresses are to
be deleted from the MAC address table. You can specify
more than one port at a time.
Description
This command deletes all of the dynamic MAC addresses learned by the
entire switch or on a specific port. After a port’s dynamic MAC addresses
have been deleted, the port begins to learn new addresses.
Examples
The following command deletes all the dynamic MAC addresses in the
switch’s MAC address table:
reset switch fdb
The following command deletes all the dynamic MAC addresses learned
on port 5:
reset switch fdb port=5