Allied Telesis AT-S63 - Manual (Page 205)

AT-S63 Management Software Command Line Interface User’s Guide
Section II: Advanced Operations 205
Caution
After downloading an AT-S63 image file into the application block
from its file system, the switch resets and initializes its management
software. The entire process can take a minute or so to complete.
Do not interrupt the process by resetting or power cycling the switch.
Some network traffic may be lost during the reset process.
Example
This command downloads an AT-S63 image file stored in the switch’s file
system into the application block, the area of flash memory reserved for
the active running image. This makes the file the active image file on the
switch. The name of the image file in the file system in this example is
“ats63v2.img”:
load method=local destfile=appblock srcfile=”ats63v2.img”
A confirmation prompt is displayed. Type Y for yes to transfer the file to the
application block or N for no to cancel the procedure.