Add qos trafficclass – Allied Telesis AT-S63 User Manual
Page 292
Chapter 19: Quality of Service (QoS) Commands
292
Section II: Advanced Operations
ADD QOS TRAFFICCLASS
Syntax
add qos trafficclass=
value
flowgrouplist=
values
Parameter
trafficclass
Specifies the ID number of the traffic class you want to
modify. You can modify only one traffic class at a time.
flowgrouplist
Specifies the new flow groups of the traffic class. The
new flow groups are added to any flow groups already
assigned to the flow group. Separate multiple flow
groups with commas (e.g., 4,11,12).
Description
This command adds flow groups to an existing traffic class. The flow
groups must already exist. Any flow groups already assigned to the traffic
class are retained by the class. If you want to add flow groups while
removing those already assigned, refer to “SET QOS TRAFFICCLASS”
on page 322.
Examples
This command adds flow group 21 to traffic class 17:
add qos trafficclass=17 flowgrouplist=21