Allied Telesis AT-S63 - Manual (Page 511)

AT-S63 Management Software Command Line Interface User’s Guide
Section VI: Virtual LANs 511
ENABLE GARP
Syntax
enable garp=gvrp [gip]
Parameters
garp Specifies the GARP application to be activated.
GVRP is the only GARP application supported by the
AT-9400 Series switches.
gip Enables GARP Information Propagation (GIP).
Note
The online help for this command contains an STP option. This
option is not supported.
Description
This command enables GVRP on the switch. After activated, the switch
will learn dynamic GVRP VLANs and dynamic GVRP ports.
You can also use this command to enable GIP. GIP must be enabled for
GVRP to operate properly.
Examples
The following command enables GVRP on the switch:
enable garp=gvrp
The following command enables GIP only:
enable garp=gvrp gip