Allied Telesis AT-S63 - Manual (Page 531)

AT-S63 Management Software Command Line Interface User’s Guide
Section VI: Virtual LANs 531
SHOW VLAN
Syntax
show vlan[= name | vid ]
Parameter
vlan Specifies the name or VID of the VLAN you want to
view. Omitting this displays all VLANs.
Description
This command displays information about the VLANs on the switch. An
example of the information displayed by this command for a protected
ports VLAN is shown in Figure 45.
Figure 45. SHOW VLAN Command for a Protected Ports VLAN
The information displayed by this command is described here:
ˆ VLAN name - The name of the VLAN.
ˆ VLAN ID - The ID number assigned to the VLAN.
ˆ VLAN Type - The type of VLAN. This will be Protected for a protected
ports VLAN.
ˆ Protected Ports - The status of protected ports. This will be Yes for a
protected ports VLANs.
ˆ Uplink Port(s) - The port that is functioning as the unlink port for the
groups of the VLAN. There can be more than one uplink port.
ˆ Group (ports) - The group number followed by the ports of the group.
ˆ Untagged port(s) - The untagged ports of the VLAN.
ˆ Tagged port(s) - The tagged ports of the VLAN.
VLAN Name ............................ Phone_staff_2
VLAN ID .............................. 12
VLAN Type ............................ Protected
Protected Ports ...................... Yes
Uplink Port(s) ....................... 23
Group (ports) ........................ 1(14)
Group (ports) ........................ 2(15)
Group (ports) ........................ 3(16-17)
Group (ports) ........................ 4(18-19)
Group (ports) ........................ 5(20)
Untagged Port(s) ..................... 14-20
Tagged Port(s) ....................... 23