Allied Telesis AT-S63 - Manual (Page 134)

Chapter 7: Port Parameter Commands
134 Section I: Basic Operations
ˆ Override Priority - Displays whether the Class of Service priority level
in ingress tagged packets is ignored when determining the egress
queue for storing the packets. If this parameter is displaying Yes, the
switch ignores the priority level in tagged packets and uses the priority
level assigned to the port to determine the egress queue. The default
setting is No. At the default setting the priority level in tagged packets
is used to determine the appropriate egress queue. To set this
parameter, refer to “SET SWITCH PORT PRIORITY
OVERRIDEPRIORITY” on page 284. To adjust the mappings of
priority levels to egress queues, see “SET QOS COSP” on page 281.
ˆ Mirroring State - Displays the state of port mirroring on the switch. If
port mirroring has been activated on the switch, this field will contain
Enabled. If port mirroring has not been activated on the switch, the
default setting, this field will contain Disabled. To configure port
mirroring, refer to “SET SWITCH MIRROR” on page 182 and “SET
SWITCH PORT MIRROR” on page 183.
ˆ Is this mirror port mirror - Displays whether the port is functioning as
the destination port of a port mirror. This field only appears if port
mirroring has been activated on the switch. This field displays No if the
port is not the destination port and Yes if it is the destination port.
For further details on port parameters, refer to Chapter 6, “Port
Parameters” in the AT-S63 Management Software Menus Interface User’s
Guide.
Note
The information for an SFP or GBIC module includes additional
nonadjustable operating specifications of the module.
An example of the information displayed by this command is shown in
Figure 7 on page 135.