Altera CPRI IP Core - Manual (Page 218)

Info–6 Additional InformationAdditional Information
How to Contact Altera
CPRI MegaCore Function December 2013 Altera Corporation
User Guide
How to Contact Altera
To locate the most up-to-date information about Altera products, refer to the
following table.
Typographic Conventions
The following table shows the typographic conventions this document uses.
December 2010 10.1
■ Added support for Arria II GZ devices.
■ Added support for additional CPRI data rates in Arria II GX devices.
■ Updated register addresses.
■ Added scrambler/descrambler support.
■ Enhanced descriptions of offset registers and delay calculations.
■ Added CPU interrupt for remote hardware reset.
■ Enhanced testbench suite to include one new testbench, to demonstrate autorate
negotiation in Cyclone IV GX devices.
July 2010 10.0
■ Added support for Cyclone IV GX devices.
■ Added GUI parameter to enable autorate negotiation and two signals to support visibility
of the feature status.
■ Enhanced descriptions of MII, MAP interface synchronous buffer mode, and use of AUX
interface mask.
■ Enhanced testbench suite to include two new testbenches, to demonstrate operation
with no MAP interface and to demonstrate autorate negotiation.
February 2010 9.1 SP1 Initial release.
Date Version Changes Made
Contact (1) Contact Method Address
Technical support Website www.altera.com/support
Technical training
Website www.altera.com/training
Email [email protected]
Product literature Website www.altera.com/literature
Nontechnical support (general) Email [email protected]
(software licensing) Email [email protected]
Note to Table:
(1) You can also contact your local Altera sales office or sales representative.
Visual Cue Meaning
Bold Type with Initial Capital
Letters
Indicate command names, dialog box titles, dialog box options, and other GUI
labels. For example, Save As dialog box. For GUI elements, capitalization matches
the GUI.
bold type
Indicates directory names, project names, disk drive names, file names, file name
extensions, software utility names, and GUI labels. For example, \qdesigns
directory, D: drive, and chiptrip.gdf file.