Code Blue TOOLVOX X3 - Manual (Page 20)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-154-F page 20 of 132
ToolVox® X3
Administrator Guide
(PRI/BRI/E1/T1/J1/SIP/IAX).
Never Override Caller ID(Optional): Check this box to disable using the Outbound CID set up in
the extensions configuration page. You must enter an Outbound Caller ID when checking this box.
Maximum Channels(Optional): The maximum number of outgoing calls that can be made
simultaneously on this trunk. Incoming calls have no effect on the maximum. A default of blank
specifies no maximum.
Disable Trunk(Optional): Disables the trunk for all routes configured.
Monitor Trunk Failures(Optional): If checked enter the AGI script that will be called to either log,
email, or take action due to a trunk failure other than CANCEL or NOANSWER.
Outgoing Dial Rules
Dial Rules(Optional): A Dial Rule to set how calls are sent out this trunk. If your outbound call
does not match anything then it will be dialed as is.
• X matches any digit from 0-9
• Z matches any digit from 1-9
• N matches any digit from 2-9
• . is a wildcard that matches one or more characters
• | removes the dialing prefix from the number dialed. Example 9|.
o This would send any number beginning with 9 out this route. 95551212 would
send 5551212 out this trunk.
• + adds a dialing prefix to the number dialed. Example 1616+.
o This would add 1616 to any number sent out this trunk. 5551212 would be
prepended and sent to the carrier as 16165551212.
Dial Rules Wizards(Optional): Useful in creating Dial Rules. You can use the wizard to add or
delete a prefix to numbers or lookup numbers for local calling.
Outbound Dial Prefix(Optional): Enter the outbound dial prefix for Centrex or other custom type of
trunks where you have to dial a 9 etc. to make a call to the PSTN.
Outgoing Settings
ZAP Identifier (trunk name): This is the group number or individual channel number of this trunk.
After you have looked in the DAHDI menu screen and noted the FXO channel numbers you need to
create one of these trunks for each FXO you wish to use.
For example if your FXO’s are 1-4 enter 1 in the Zap Identifier (trunk name) field. Then create 3
more trunks, 2,3, and 4. Your Outbound Route will need to be created that will reference these
trunks as available routes.
If using a PRI T1, use the group number you were assigned in DAHDI. Example g3
To save your settings click: