Code Blue TOOLVOX X3 - Manual (Page 33)

Code Blue • 259 Hedcor Street • Holland, MI 49423 USA • 800.205.7186 • www.codeblue.com GU-154-F page 33 of 132
ToolVox® X3
Administrator Guide
Ring Down and ANI – Ring down selection & Automatic Number identification (ANI). Selections
0-3 are available only for standard trunk lines, while selections 4-6 are available only for analog ring
down lines. Note: this was originally for RPD/CMS. For most users you only need to select whether
this CB phone is connected on a Dial up phone line or a Ring Down/Hot line.
Call Button (CB3100 only) – This command is used with the CB3100K keypad faceplate to allow
for a number to be automatically dialed before using the keypad.
Ring Back Detection (CB3100 only) – Call progress monitor for hang up.
Wink Time (CB3100 only) – This is the minimum amount of time that talk battery is removed or
reversal of polarity for the CB phone to hang up. 2=200 milliseconds etc. 0-9
In Call Commands (CB3100 only) – The operators ability to send commands during a call.
Ring Time – The amount of time the phone will try a number before resetting and dialing the next
number 00-60.
Dial Type (CB3000 only) – Phone line uses Pulse or DTMP encoding
Other Options (cont.)
Auxiliary #2 – Determines whether Auxiliary output #2 (pins 7&8) activate the same as Auxiliary
output #1 (pins 5&6 Slaved) or by pressing the 6 key during a call (Unslaved).
Auto Connection – If Auxiliary output #2 is unslaved from Auxiliary output #1, Disabling allows the
use of the In Call Command (DTMF 6) to activate Auxiliary output #2. If enabled Auxiliary output #2
will activate on an incoming call.
Auxiliary #2 Active Time – The amount of time Auxiliary output #2 will stay active. 00=Active for
the duration of the call. 01-89=Active for 1-89 minutes. 90-99=5-50 seconds in 5 second increments
(90=5 seconds, 91=10 seconds, etc.)