Automation connection – Grass Valley Maestro Master Control v.1.7 User Manual
Page 118
Advertising
114
Maestro Channel Branding User Guide
Section 5 — The Maestro Configuration Editor
Automation Connection
This window has a table that defines the connection parameters that
connect the Maestro Master Control system to an Automation system.
When the Automation Connection hyperlink is selected, the “set panel”
will then open.
Figure 89. Set Panel (typical)
Name
Enter a name for the Automation Connection set. Then select the
New
button,
an Automation Connection window with a set table, will then
appear.
Figure 90. The Automation Connection Window
Connection Type
Select “Serial.” This identifies the Maestro’s rear-panel “Automation” port.
Protocol
Select “ES.”
Advertising