Grass Valley Maestro Master Control v.1.7 - Manual (Page 169)

Maestro Channel Branding User Guide 165
5th Step: Input/Output Sets
Trigger Type
Selections are Pulse or Level. For Jupiter/MI-3040 applications, select
Level.
Trigger Duration
This column applies only when “Pulse” has been selected as the Trigger
Type. Not used for Jupiter applications.
Trigger Sense
Selections are High (that is, bring line high when bus is on Air) or Low (that
is, bring line low when bus is on Air. For Jupiter/MI-3040 applications,
select High.
Sub System
Select “Bus Tally.”
Purpose
When “Bus Tally” has been selected, these selections refer to the various
Maestro input busses. Select the input that is to be associated with the GPIO
port being configured. In the example shown, when Maestro input “Bus A”
is contributing to the channel output, GPIO port 1 on the rear panel will be
activated.
When finished select “ Apply ” or “ OK .” The Name of the GPIO Definition set
will now appear in the set panel. The set is assigned to the appropriate
Maestro channel using the Channel Setup table.
Jupiter/MI-3040 Configuration
These notes assume that the installer is familiar with installation and con-
figuration of the MI-3040 for use with tally systems, as described in the
Jupiter manual. If not, the reader should review the MI-3040 Tally Installa-
tion instructions beginning with the Hardware Installation section of that
manual. The Maestro application is similar to that described for “Jupiter
Tally Systems.”
Note The Jupiter manual mentions a “Saturn Tally” system, but this applies only to
Saturn Master Control systems with an internal switching matrix. The
installer should follow the instructions for “Jupiter Tally Systems.”
In general, the MI-3040 must be established as an MPK device for tally use,
after which it is referred to as an “MI-3040T.” The Jupiter Tally Relay and
Tally Dependency tables must also be filled in, as described in the Jupiter
manual.
Special Notes for Jupiter Configuration
MPK Devices Table
Enter the MI-3040 as described in the Jupiter manual. There is no entry
for a device of type “MCS_TLY.”