Grass Valley Maestro Master Control v.1.7 User Manual
Page 189
Maestro Channel Branding User Guide
185
7th Step: Effects Configuration
The Active Effect choices are:
•
Exit->Pgm - This exit mode unsqueezes the source in the squeeze
window (Pgm) leaving the Pgm video full screen.
•
Exit->Pst - This exit mode replaces the on-air effect with the video
selected on the Pst bus.
•
Exit->Aux -This exit mode squeezes the squeeze window (Pgm) until it
disappears leaving only the background video (Aux) on screen. At the
end of the transition, Aux video moves to the Pgm bus.
•
Audio Only - This exit mode transitions only the audio. The active
video effect is unchanged. The audio that will be on-air after pressing
the
TAKE
button is selected with the
DVE Audio Mode
button. Available
audio modes are determined by the “Available Audio Mode” selections
explained below.
•
Aux<->Pst - This is a cut-only transition that replaces the current back-
ground video (Aux) with the video selected on the Pst bus. The selected
transition type and rate are disabled.
•
SwapPgmAux - This is a cut-only transition that swaps the background
(Aux) and squeeze window (Pgm) video. The selected transition rate
and type are disabled.
•
Pst>Pgm>Aux - This exit mode rotates the sources on all three busses
in the direction indicated by the “>.” This is a cut-only transition. The
selected transition rate and type are disabled.
•
Pst<Pgm<Aux - This exit mode rotates the sources on all three busses
in the direction indicated by the “>.” This is a cut-only transition. The
selected transition rate and type are disabled.
Figure 142. DVE Active Effect Selections