Honeywell VRX180 - Manual (Page 177)

Programming Function Blocks and Features
Video Recorder – User Manual 163
4.23 Load/Store Configuration
Instrument configurations can be stored to and loaded from floppy disk. The front door must be closed.
Configurations have filename extension .LNC.
Table 4-69 describes the Load/Store Config prompts.
Table 4-69 Load/Store Config Files Prompts
Prompt Range/Selections Definition
STORE CONFIG TO
DISK
FILE01 CYCLE01
DRYER01 PROD01
RECORD01 TANK01
UNIT01 LOOP01
REACTR01 CONFIG01
KILN01 VESSEL01
CALIB01 WCHEM01
PRESS01 FURNCE01
DEMIN01 CONTRL01
BATCH01 FERMTR01
LEHR01 LINE01
STRLZR01 OVEN01
ZONE01
Specify a filename and number (01-99) for the
configuration. Press Enter to store the configuration.
LOAD CONFIG
FROM DISK
Select a configuration
filename. First you must clear the instrument’s configuration memory.
Press Enter to clear, or Menu to abort and exit the menu.
Once the memory is clear, select a filename from the floppy
disk. Press Enter to load the configuration into the
instrument.
ATTENTION
Only function blocks that have been programmed are loaded to the instrument. Function blocks in the receiving
instrument are not replaced unless the incoming function blocks are programmed differently. For example, if the
instrument has AI1 and AI2 programmed, and the configuration being loaded from the floppy contains AI3 only,
then AI1 and AI2 are undisturbed on the instrument and AI3 is added. If the configuration being loaded contains a
different AI2 and a new AI3, then AI1 is undisturbed, AI2 is replaced by the different AI2, and AI3 is added.