Multi-Tech Systems MTASR1-100 - Manual (Page 113)

Chapter 6 - Configuration Examples
113
In the RouteFinder 100 Setup dialog box click on the WAN button.
12. The WAN Port Setup dialog box is displayed with the Port Enabled, Mode set for Asynchronous, and the
Connection Method set to Direct Connect/Leased Line and Answering.
With a dial-up line and an async modem, the Mode needs to be Asynchronous (the default) and the
Connection Method needs to be either Answering or Dialing. For the Chicago site it needs to be Dialing.
With a leased line, the Mode needs to be Synchronous and the Connection Method needs to be Direct
Connect/Leased Line.
For a dial-up connection, perform steps 13,14,and 15 and then skip to step 17.
For a leased line connection, skip to step 16.
13. Change the Connection Method to Dialup by clicking on the Dialing check box.
For the Chicago LAN, the WAN Port Setup dialog box should have the following fields checked:
x Port Enable x Asynchronous
x 115200 x Dialing
14. Click on the Advanced button to display the WAN General Setup dialog box.