Multi-Tech Systems MTASR1-100 - Manual (Page 40)

MTASR1-100 Owner’s Manual
40
WAN Procedure
36 If you clicked on the OK button from the IP Protocol Default Setup dialog box, the WAN Port Default Setup
dialog box is displayed. The WAN Port is enabled in this dialog box.
37 If the WAN port is being connected to an asynchronous device and is being used for Answering, click on
the Answering check box. Then proceed to steps 39 and 40 to set the speed and modem type.
If the WAN port is being connected to an asynchronous device and is being used to dial, click on the
Direct Connect/Leased Line and the Dial Number text box becomes active. Enter the phone number of
the RouteFinder
100 at the other end of the communications network. Then proceed to steps 39 and 40 to
set the speed and modem type.
38 If the WAN device is a synchronous device, click on the Asynchronous check box. The RouteFinder 100
assumes that the synchronous device will provide the clocking signal for the data on the WAN port. You
must make sure the synchronous device is set up for this; refer to the user documentation for the
synchronous device to set the clocking. Proceed to step 41.
39 If the WAN device is an asynchronous device, click on the speed arrow and the drop down list box
displays the baud rate for the WAN device. Refer to the user documentation for the WAN device baud
rate.
40 If the WAN device is an asynchronous device, click on the Modem Type arrow and the drop down list box
displays the supported modems. Highlight your modem type.
41 Click on OK when you are satisfied with your selections.
If your WAN port is connected to an asynchronous device, proceed to step 52.
If your WAN port is connected to a synchronous device, proceed to step 42 to determine if frame relay is
going to be used.