Multi-Tech Systems MTASR1-100 - Manual (Page 38)

MTASR1-100 Owner’s Manual
38
Figure 4-1. IPX Protocol Worksheet
20 Assign a Router Name to the RouteFinder on LAN 1. Write the name in the IPX Worksheet. This name
must be unique to the entire inter-network.
21 Assign a WAN Network number of the WAN connection on the RouteFinder in LAN 1. Write the number
in the IPX Worksheet.
22 Record the network numbers assigned by the network file server for each of the four frame types (Raw
(802.3), LLC (802.2), EthernetII (Type II), SNAP) for LAN 2 in the IPX Worksheet.
23 Assign a Router Name to the RouteFinder on LAN 2. Write the name in the IPX Worksheet This name
must be unique to the entire inter-network.
24 Assign a WAN Network number of the WAN connection on the RouteFinder in LAN 2. This number must
be in the same network as the WAN number on LAN 1. Write the number in the IPX Worksheet.
25 Click on the WAN field default network number and change the default number to the number you have
assigned for the WAN port on your LAN.
Click on OK when you are satisfied with your selections.
26 If frame relay is being used as the WAN service and is being connected to an IPX network, proceed to
step 42.