Multi-Tech Systems MTASR1-100 - Manual (Page 70)

MTASR1-100 Owner’s Manual
70
Modifying Parameters of a DLCI
Select the DLCI for which parameters have to be changed, then change the required parameters. Once you
make a change, the Save Changes button is enabled which allows you to save the changes.
IP Address
If you want to map the currently selected or added DLCI to an IP Address, then you should check this option. It
will allow you to map the DLCI to one of the IP Addresses. IP Addresses shown here will include the currently
added IP Addresses also.
IPX Network Number
If you want to map the currently added or selected DLCI to a Network Number, then this check box has to be
checked and clicking on the down arrow in the Network Number list box. It will display the currently available
Network Numbers.
STP Port Number
If presently selected or added DLCI has to be mapped to a Spanning Tree Port (STP), then check this option.
It displays the available Port for configuration in its combo box out of which only one has to be selected.
5.2.12 SNMP (Simple Network Management Protocol) Setup
RouteFinder’s SNMP related parameters are configured through this dialog box. The SNMP Setup dialog box
is displayed by clicking on the SNMP button in the Router Setup dialog box.
SNMP Enable = [enabled | disabled]
Enables or disables SNMP management support.
SNMP Local Internet Address = [doted decimal address]
The local internet IP address for SNMP in the dotted decimal format.
This is always set to be the same as the IP address of the Ethernet port and can not be edited.
Message Printing Control
Check items in this group for messages on various conditions. Normally all items should be disabled to
prevent degradation in router performance.