Enable dumb terminal management, Enable terminal server (telnet), Enable tftp server – Multi-Tech Systems MTASR1-100 User Manual
Page 72: Default telnet server ip address
MTASR1-100 Owner’s Manual
72
A WAN port will NOT be available for device configuration if:
It is already used for routing,
It is already used for dialing out,
There is a call back in progress,
It is used for configurating a device connected to it.
5) Modify remote user database - This option in the Telnet server lets you view, create and modify user
information maintained in the RouteFinder
100
. This user database is used for dialing in and dialing out clients.
Enable TFTP Server
The RouteFinder
100
also has a built-in TFTP Server for configuration and firmware updates across the IP
internetwork. TFTP is a file transfer protocol that uses UDP and provides a simple method for transferring files
between two nodes (the server and a client).
Check this option to enable the TFTP Server
IMPORTANT: For security reasons, this option should be disabled once your RouteFinder
100
is setup
completely since anyone on the internetwork can change the routers configuration by performing a TFTP
upload.
Enable Dumb Terminal Management
A router administrator can connect a dumb terminal to the command port (directly or using modems and
access the router for configuation and management. If you plan to use this feature, check this option.
Enable Terminal Server (Telnet)
The MultiRotuer has a built-in telnet client which can connect an incoming call from a terminal (dumb or
intelligent) to a telnet server. Check this option to use this feature.
Default Telnet Server IP Address
Enter the IP address of the Default Telnet host address here. When the MultiRotuer tries to look for a telnet
host to connect to, it first will look in the WAN port specific telnet host address field. If no host address is
found in that field, the router will look in this field for the address of a telnet host. If both fields are empty, the
user will be asked to type in the address of the telnet host to connect to. (If DNS resolver is enabled and the
DNS Name server is available, the user can enter the domain name instead of the IP address).