Multi-Tech Systems MTASR1-100 - Manual (Page 65)

Chapter 5 - RouteFinder Software
65
WAN General Setup
This dialog box lets you configure some parameters related to the WAN port. The WAN General Setup dialog
box is displayed by clicking on the Advanced button in the WAN Port Setup dialog box.
WAN Message Printing Control
Check items in this section that you want to be displayed on console messages. Normally all items should be
disabled to avoid degradation of router performance.
Script Printing
This group allows script printing during NonCritical periods or during an alarm condition.
Modem Control
You may use this control to set up the command and response strings of connectable modems. The
RouteFinder stores the information about all types of modems in a common modem configuration file, called
modems.cnf. The configuration file contains the commands that you want sent to the modem before dialing
out.
Modem Type
Notice, that the modem highlighted in this dialog box is the modem you specified on the current
communications link. Additionally, you will see the selected modem's communications strings.
You may program the Dial Prefix and Suffix, Ring Message, Hangup String, and Modem command responses.
Refer to Appendix B for an explanation of the modem commands.