Multi-Tech Systems MTASR1-100 - Manual (Page 175)

Chapter 9 - Dial Out Client Software
175
Note: This screen will not pop up if the MCSIWSN command line did not contain the -P parameter
(display pop up). For more information on MCSIWSN's command line parameter options see the previous
section in this chapter.
7. If you select an OUTBOUND modem, your dial-out session will operate as described in your
communications software manual. Go to step 11 to complete this procedure.
Note: OUTBOUND is selected for any of the following sessions: dial-out data communications, auto-
answer data communications, send fax, and receive fax directly to your desk.
OR
If you select an INBOUND modem, run your communications software and wait for a dial-in call. All of your
assigned lines will be monitored for a dial-in call. When a dial-in call is received, the following appears.
8. You are asked to "ENTER HOST ID YOU WANT TO CONNECT TO?". Type in a HOST ID number (listed
in the left-hand column).
9. You may be asked to enter a password (if there is one).
10. Upon receiving the user’s valid password, you are connected to the HOST that was configured for the
INBOUND session with the User Name and Password that was just verified. Your dial-in remote control
session can now continue as described in the manual that accompanied your communications software.
11. When your session is concluded, use the disconnect modem feature on the communications program to
free the modem and port for other users.