3 using multiexpress with mcsi, Connection type menu, Using multiexpress with mcsi – Multi-Tech Systems MTASR1-100 User Manual
Page 174: Meterm, Multiexpress
MTASR1-100 Owner’s Manual
174
9.2.3 Using MultiExpress with MCSI
At this point you have run MCSIWSN according to the procedure in either Section 9.2.1 or 9.2.2. This section
will indicate how to use MultiExpress to connect with the MultiRouter modem. It is assumed that MultiExpress
has been installed on your client PC.
Note: Any LAN network communications software program with a MCSI compatible interface can be used to
establish a session with the MultiRouter modem.
1.
If MultiExpress has not been installed, then install it by placing the MultiExpress disk in the floppy drive,
typing MEINSTALL and pressing Enter.
2.
Run METERM by typing METERM and pressing Enter. The opening title Screen appears and then the
main screen appears.
3.
If the status line at the bottom of your screen indicates COM1 or a connection type other than MCSI.
Then press ALT+L to pop up either the question shown below if a connection was active or the screen
shown in step 4.
4.
If a session was active drop the session by selecting "YES" and pressing Enter. The Connection Type
Menu appears.
5.
Select MCSI as your connection type by highlighting MCSI and pressing Enter. The following screen
appears.
6.
If the MultiRouter is the only communications server on your LAN, you can press F2 to connect to the
MultiRouter modem. The Modem type OUTBOUND/INBOUND screen appears.