Multi-Tech Systems MTASR1-100 - Manual (Page 134)

MTASR1-100 Owner’s Manual
134
26. Move to the Settings (in Bits/second) group and lets leave the Committed Information at 56000, but
change the Excess Burst Rate (Be) from 0 to 9000. Click on the 0 and back space thru the 0 and then
enter 9000.
27. Finally click on the Add button to configure DLCI 51.
28. The External Clocking Enabled. Ensure Proper values for Excess Burst Rate and Committed Information
Rate dialog box is displayed, click on OK to configure DLCI 51.
29. Click on the OK button in the Frame Relay DLCI dialog box to return to the Frame Relay Setup dialog
box.
30. Click on the OK button in the Frame Relay Setup dialog box to return to the Main menu.
31. Click on the Download Setup button to down load the frame relay configuration to the RouteFinder.
32. Click on the OK to continue.
The "Looking for response from RouteFinder" dialog box is displayed momentarily.
33. The Writing setup dialog box is displayed as the setup configuration is written to the RouteFinder.