Multi-Tech Systems MTASR1-100 - Manual (Page 62)

MTASR1-100 Owner’s Manual
62
Point-To-Point Protocol (PPP) General Setup
This dialog box lets you setup general PPP options for a WAN port. This dialog box is displayed by clicking on
the Adanced button in the PPP Port Setup dialog box.
PPP Echo Requests Maximum Number = [decimal value]
Defines the number of unacknowledged LCP Echo Requests that will trigger terminating the link to the peer.
Recommended value: 20
PPP Echo Requests Send Interval Maximum = [decimal value]
Defines the interval, in seconds, that the LCP will insert between two consecutive LCP Echo Requests.
Recommended value: 5
PPP Termination Requests Maximum Number = [decimal value]
Defines the maximum number of LCP Termination Requests issued after completion of a back off interval.
Once the maximum is reached with no response from the peer, LCP will commence issuing LCP Configuration
Requests.
Recommended value: 10
PPP Termination Requests Send Interval Maximum = [decimal seconds]
Defines the interval, in seconds, that the LCP will insert between two consecutive LCP Termination Requests.
Recommended value: 5
PPP Configuration Requests Maximum Number = [decimal value]
Defines the number of LCP Configuration Requests to be sent befire backing off due to no response from the
requests.
Recommended value: 20
PPP Configuration Requests Send Interval Maximum = [decimal seconds]
Defines the interval, in seconds, that the LCP will insert between two consecutive LCP Configuration
Requests.
Recommended value: 5
PPP Configuration Request Backoff Interval Maximum = [decimal seconds]
Defines the interval, in seconds, that LCP will insert once the unanswered PPP Maximum Number Of
Configuration Requests has been reached. Once this interval has transpired, PPP will commence termination
of the link. See PPP Maximum Number Of Termination Requests.
Recommended value: 10