Multi-Tech Systems MTASR1-100 - Manual (Page 45)

Chapter 5 - RouteFinder Software
45
Certain options are enabled depending on the state of the target. If no RouteFinder (target) is found, click on
the Configuration Port Setup icon in the RouteFinder program group, specify the right local port parameters
and retry running this application. You can also connect to the target through a dialup modem.
RouteFinder setup also has a console terminal for displaying various debugging messages output from the
target. You can control the display of these messages using this application. Normally you should turn off the
display of all messages for better performance of the router.
5.2.2 Protocol Stacks
IP
This button selects the Internet Protocol setup.
IPX
This button selects the Novell Internet Packet Exchange (IPX) protocol setup.
Spanning Tree (Bridging Protocol)
This button allows you to select either transparent bridging or bridging using the Spanning Tree Algorithm
setup as specified in the IEEE 802.1d standard.
5.2.3 Device Drivers
PPP
This button selects the Point-to-Point Protocol (PPP) setup.
Frame Relay
This button selects the Frame Relay setup.
WAN
This button selects the Wide Area Network (WAN) link setup.