Multi-Tech Systems MTASR1-100 - Manual (Page 26)

MTASR1-100 Owner’s Manual
26
2.4 Shunts
The shunts are on the back of the printed circuit board. The shunts are shown in Figure 2-3.
RS232
Shunt Position
V.35
Shunt Position
Figure 2-3. Shunts
The RouteFinder has a shunt for the RS232 and the V.35 links. The shunts are shown in Figure 2-3. The
RS232 shunt position, the default position, is shown in the figure and the V.35 position is identified. To
change the position of a shunt, refer to the V.35 Shunt procedure in Chapter 3.