Multi-Tech Systems MTASR1-100 - Manual (Page 171)

Chapter 9 - Dial Out Client Software
171
9.2.1 Using the MCSI Software Redirector
1. Change to the subdirectory containing the MCSI files, e.g., C:\MCSI>.
2. Type MCSIWSN (the program name for the redirector software) and press Enter.
Note: Use the -P parameter (i.e., MCSIWSN -P) to display the Inbound/Outbound Modem Type window
later when you use MCSI with MultiExpress. For more information on MCSIWSN's command line
parameter options see Section 9.2.2. For more information on using MCSI with MultiExpress see Section
9.2.3.
This loads the redirector software. A message similar to the following appears:
3. Type LOGON and press Enter. A message similar to the following appears:
You can use a preferred communications server name if more than one communications server is on the
network, e.g., logon server_1/user1.
4. Type USER1 (or your valid MultiComRNGateway user name) and press Enter. If a password has been
assigned, the following appears. (If a password was not assigned, then the screen in Step 8 appears.)
5. Type USER1 (or your valid MultiComRNGateway password) and press Enter. The following appears:
6. You have now connected to the MultiRouter modem and can run any MCSI compatible software to
establish a connection.
At some point you may want to unload MCSI from memory. This is done by changing to the directory
where MCSI is located, typing MCSIWSN -U and pressing Enter. MCSI will then unload from memory,
provided that other TSR's have not been loaded after MCSI was loaded. If other TSR's have been
loaded, then they must be unloaded in the reverse order of loading, before MCSIWSN can be unloaded.