Multi-Tech Systems MTASR1-100 - Manual (Page 151)

Chapter 7 - Remote Configuration
151
7.3 LAN-Based Remote Configuration
Windows Sockets Compliant TCP/IP Stack
SNMP requires a Windows Sockets compliant TCP/IP stack. Microsoft provides a TCP/IP stack free for
Windows for Workgroups 3.11. TCP/IP protocol software must be installed and functional before SNMP can
be used.
1 You must assign an internet (IP) address for the PC and for each node that will be managed by SNMP.
Refer to the protocol software documentation for instructions on how to set the IP addresses.
Once you have completed this step, you should be able to use the protocol Ping command for the PC host
name. You should also test the network interface configurtion by Pinging another TCP/IP device that is
connected to the network.
2 Install the RouteFinder software on the local PC and at the Windows Program Manager screen, double
click on the Configuration Port Setup Icon.
3 The Port Setup dialog box is displayed.
Verify that the Communication Type field is set IP.
In the Router IP Address field, enter the IP Address of the remote RouteFinder 100 .
4 Click on OK when you are satisfied with your selections.
The windows Program Manager menu is displayed.
5 Double click on the Router Configuration icon.