Multi-Tech Systems CDMA Wireless Modem - Manual (Page 104)

Chapter 14 – Specific AT Commands
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 104
CPHS Command +CPHS
Description: This command is used to activate, deactivate or interrogate a CPHS feature (e.g. Voice Mail
Indicator). When performing an interrogation (mode = 2), the selected <FctId> CPHS feature
is automatically enabled (status = 1).
Note: This command may answer +CME ERROR: 3 if the CPHS feature is disabled.
Values:
<Mode>
0: Deactivate a CPHS feature
1: Activate a CPHS feature
2: Interrogate a CPHS status
<FctId>
1: Voice Mail Indicator
<Status>
0: CPHS feature disabled
1: CPHS feature enabled
Syntax:
Command syntax: AT+CPHS=<Mode>,<FctId>
Command Possible Responses
AT+CPHS=<Mode>,<FctId> OK
AT+CPHS? +CPHS: <Status>,<FctId1><CR<LF>
OK
AT+CPHS=?
Note: display the range of values +CPHS: (0-2),(1-1)
OK
Change Default Player +WCDP
Description: This command is used to select the default destination for the melody player.
Note: Selection of the player will have effect on the setting of the WCDM command.
Values:
<player>
0: Speaker
1: Buzzer
Syntax:
Command syntax: DP = <player>
Command Possible Responses
AT+WCDP=? +WCDP : (0-1)
OK
AT+WCDP=0
Select the speaker. OK
AT+WCDP? +WCDP: 0
OK