Hang-up command h – Multi-Tech Systems CDMA Wireless Modem User Manual

Page 35

Advertising
background image

Chapter 5 – Call Control Commands

Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C

35

Phonebook
Syntax:

Command syntax: ATD><index>[;]

ATD>[<mem>]<name>[;]

ATD>[<mem>]<index>[;]

Command

Possible Responses

AT+CPBS?
Note: Which phonebook is selected.

+CPBS: ME,11,100
OK
Note: Command executed

ATD>5;
Note: Dial location #5 from ME
phonebook.

OK
Note: Command executed
+WORG:5551212
Note: Voice call origination sent to Base Station with dialing
string “5551212”.
+WEND: 3
Note: Call Attempt failed/ended. Reason 3, signal faded.
See Chapter 14, Unsolicited Commands.

ATD>SM202;
Note: Dial location 202 from the
SM(RUIM card) phonebook.

OK
Note: Command executed
+WORG:5551212
Note: Voice call origination sent to Base Station with dialing
string “5551212”.

+WEND:

3

Note: Call Attempt failed/ended. Reason 3, signal faded.
See Chapter 14 on Unsolicited commands.

ATD>”Bill”;
Note: This command is NOT valid for
MC, RC, and LD phonebooks as they
are supported in CDMA networks

OK
Note: Command executed
+WORG:5551212


Note:
When the FD facility is enabled, only the numbers in the FDN phonebook can be
called. For example, if “014629” is present in the FD phonebook, the command ATD014629;
will be successful. Data calls are not allowed when the FD facility is enabled.

Hang-Up Command H

Description: The ATH (or ATH0) command is used by the application to disconnect the remote user. In

the case of multiple calls, all calls are released (active, on-hold and waiting calls).

The specific ATH1 command has been appended to disconnect the current outgoing call,
only in dialing or alerting state (i.e. ATH1 can be used only after the ATD command, and
before its terminal response (OK, NO CARRIER, ...). It can be useful in the case of multiple
calls.


Syntax:

Command syntax: ATH

Command

Possible Responses

ATH
Note: Ask for disconnection

OK
+WEND: 10
Note: Every call, if any, is released

ATH1
Note: Ask for outgoing call
disconnection

ERROR
+WEND: 10
Note: Outgoing call, if any, is released

Advertising