Multi-Tech Systems CDMA Wireless Modem - Manual (Page 152)

Chapter 19 – Qualcomm Defined AT Commands for CDMA Operation
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 152
Reset RLP Protocol Statistics $QCRLPR
Description: This command is used to zero all the RLP statistics counters. This does not apply to RLP 3
statistics (see $QCRL3R).
Syntax:
Command syntax: AT$QCRLPR
Command Possible Responses
AT$QCRLPR?
Note: Display the current setting ERROR
Note: Command is not valid
AT$QCRLPR
Note: Reset RLP statistics counter $QCRLPR:
OK
Note: Command is valid
Dump PPP Protocol Statistics $QCPPPD
Description: This command is used to dump the PPP statistics in ASCII format to the DTE.
Syntax:
Command syntax: AT$QCPPPD
Command Possible Responses
AT$QCPPPD?
Note: Display the current setting ERROR
Note: Command is not valid
AT$QCPPPD
Note: Dump PPP statistics information $QCPPPD:
In LCP :0000 Out LCP :0000
….
OK
Note: Command is valid
Reset PPP Protocol Statistics $QCPPPR
Description: This command is used to zero all of the PPP statistics counters.
Syntax:
Command syntax: AT$QCPPPR
Command Possible Responses
AT$QCPPPR?
Note: Display the current setting ERROR
Note: Command is not valid
AT$QCPPPR
Note: Reset PPP statistics counter $QCPPPR:
OK
Note: Command is valid
Dump IP Protocol Statistics $QCIPD
Description: This command is used to dump the IP statistics in ASCII format to the DTE.
Syntax:
Command syntax: AT$QCIPD
Command Possible responses
AT$QCIPD?
Note: Display the current setting ERROR
Note: Command is not valid
AT$QCIPD
Note: Dump IP statistics information $QCIPD:
IP:
InReceives :0000 InHdrErrors :0000
….
OK
Note: Command is valid