Multi-Tech Systems CDMA Wireless Modem - Manual (Page 132)

Chapter 17 – Extended AT Commands in IS707.3
Multi-Tech Systems, Inc. CDMA Wireless AT Commands - PN S000294C 132
Select Pulse Dialing P
Description: This command is used to select pulse dialing. Not relevant to CDMA data services; “P” is not
sent in dial string.
Syntax:
Command syntax: ATP
Command Possible Responses
ATP
Note: select pulse dialing. OK
Note: Command is valid
Basic S-Registers S<X>
Description: The S-registers store configuration parameters that are used for dialing or during an
established call. The value of an S-register may be set by using the syntax: ATSn=<value>
where n is the register number and <value> is a decimal value.
Values:
<n> ATS command index. Ranges from 0-11.
<value> Value for the ATS command.
Syntax:
Command syntax: ATS<n>=<value>
Command Possible Responses
ATS<n>=<value>
Note: set S-registers value OK
ATS0?
Note: Disable or enable automatic answering (value: 0-255)
0: Disable;
1-255: Enable after [(value-1)x6 sec.] 002
OK
Note: always 3 characters padded with
zeros
ATS3?
Note: Carriage return character 013
OK
ATS4?
Note: Line feed character 010
OK
ATS5?
Note: Backspace character 008
OK
ATS6?
Note: Pause before blind dialing (value: 2-10) 002
OK
ATS7?
Note: Number of seconds to establish end-to-end data connection
(value: 1-255) 050
OK
ATS8?
Note: Number of seconds to pause when “,” is encountered in dial
string (value: 0-255) 002
OK
ATS9?
Note: Carrier detect threshold in increments of 0.1 seconds
(value: 0-255) 006
OK
ATS10?
Note: Number of tenths of a second from carrier loss to
disconnect (value: 1-254)
Value 255: disable carrier detect 014
OK
ATS11?
Note: DTMF tone duration and spacing in milliseconds (value: 50-
255) 095
OK